![]() ![]() The Spindle (or laser) PWM Proportional to XY Feed Rate should be left blank : You can also verify that the pulse width is the same as below, ie 4 µs: You should also change the base Hz setting to 10 000 Hz (ie. Please make sure that the PWM is ticked. ![]() Please make sure that the XY PWM velocity output is left blank In Mach3's Menu ->Plugin Control -> Spindle, THC & Laser Config Set output signal in Mach3's Menu -> Config -> Ports & Pins -> Output Signals to port 3 pin 17 In Mach3's Menu -> Config -> Ports & Pins -> Spindle Setup : disable Spindle Relays, set all delays to 0, enable PWM control and use Spindle Motor Output: Important: Please make sure that you have the ESS plugin for Mach 3Ĭonnect Spindle PWM signal to Pin 17 Port 3 in Mach3’s Menu -> Config -> Port and Pins -> Motor Outputs ![]()
0 Comments
Leave a Reply. |